Mustang Bullitt Forum banner

#1598 Hits the roller.Happy happy happy

5K views 16 replies 10 participants last post by  tigerhonaker 
#1 ·
Today, kooks LTs, Hot rod cams, Steeda CMDP and UDP, JLT 110mm CAI. 341.78 RWHP & 333.87 tq. Run on a Dynojet roller at Dasilva Racing in Pickering Ontario. It was worth the wait.:rolling:
 
#2 ·
#4 ·
Thanks 73 Mach 1
 
#6 ·
Good numbers, right where they should be.
 
#11 · (Edited)
Thanks all, the mufflers are KR 5230s. Idle set at 825. After some seat time, I can say I love it. Next up is alum driveshaft with 4.10s and some rear rubber.
 
#12 ·
4.10,s ;-)
 
#13 ·
So, I wonder what "smiles per gallon" you get now with your Bullitt?
 
#15 ·
Fergie,

You will Luv the FRPP 4:10 gears !!!

I ran them for many-many years.

LT headers with your other changes should work excellent.


You might check with if your in the (Market) for some LT headers.


They will be pulling my LT Kooks Headers with the Kooks High-Flow Cats and H-Pipe next week.

I don't know if they have already had someone ask for them yet but if you want to save some Dollars I would give them a call and check.

They handle all that sort of thing for my Bullitt Mustang.

There are a lot of high-dollar take-off parts coming off my Bullitt you might want to ask them about.

You can talk to Brent White (Owner) or George Dockery when you call.

That is if you are interested .........

Terry
 
#16 ·
Thanks for the info Terry. I am currently running Kooks LTs and high flow H pipe, They do work well, Thanks again for you sweet how to and parts reviews.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top