Mustang Bullitt Forum banner
1 - 2 of 2 Posts

· Registered
197 Posts
Discussion Starter · #1 ·
I was looking for a brushed finish tip like the originals, but slightly larger to fill in the cut-out a little better. No luck, so I got a good deal on some chromed tips and took it to a plating shop to have them put a brushed finish on. I should get them back by Fri. I'll try to post pics after I get them installed.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.