Mustang Bullitt Forum banner

1 - 3 of 3 Posts

·
Banned
Joined
·
7,235 Posts
Discussion Starter #1
While under my Bullitt,installing the MIL elims.,I couldn't believe how close the FUEL LINES are to the driveshaft! They run right in the driveshaft tunnel about an inch or more from that spinning shaft,the full length! Now what if someone is doing some hard drag racing and a U-joint fails....That line will get it big time!!
 

·
Banned
Joined
·
7,235 Posts
Discussion Starter #2
If you are going to drag race heavily....lots of power and slicks,get a good drive shaft loop front and rear.
 
1 - 3 of 3 Posts
Top