Mustang Bullitt Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
394 Posts
Discussion Starter · #1 ·
I'm curious. Are they basically a honed and polished head or are they a different design. I am considering getting the intake extrude honed and the heads cleaned up as well. If the heads flow significantly better than stock and are not that much more than extrude hning and polishing I might go this route instead.

Eric
 

·
Registered
Joined
·
10,357 Posts
The heads have been pushed to their limits. Full race porting and polishing, larger valves, bowl blending, gasket matched, 5-angle valve job, and had them decked 30`

JBVobra, you coming out on the 20th?
_________________


<font size=-1>[ This Message was edited by: Black Sunshine #161 on 2002-01-14 12:36 ]</font>
 
1 - 6 of 6 Posts
Top