Mustang Bullitt Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
540 Posts
Discussion Starter #1
If anyone is looking for just mufflers, I have 2 2.5 They were never actually put on the car, I decided to go with a mandrel bent cat back system instead.
1 on the boxes was never opened, the other I opened to look at. $250 shipped anywhere in country.

Tyler

_________________
#4932 Black
2.5" borla exhaust and custom 3" x-pipe w/ built in high flow cats.
125 shot NOS w/ polished bottle. (Have yet to use)

<font size=-1>[ This Message was edited by: 1NastyFordGT on 2001-10-31 01:37 ]</font>
 

·
Registered
Joined
·
540 Posts
Discussion Starter #2
ok everyone i am entertaining offers on these now
 

·
Registered
Joined
·
540 Posts
Discussion Starter #3
let me know when i am just going to leave them in the box
 

·
Registered
Joined
·
540 Posts
Discussion Starter #5
they are a shorter than the stock mufflers and would need a short addition of tubing to each end to get them mounted to the stock system. if you look at the stock mufflers the inlet is on the front corner and the outlet is on the opposite corner on the rear. the borla's are straight through, so you would need to compensate for the couple inches of difference in piping where the inlet and outlets on the stock mufflers used to be
 

·
Registered
Joined
·
124 Posts
I don't know how hungry you are yet, but I'll take them for $100. I was going to have magnaflows welded in for $200 installed.
 
1 - 6 of 6 Posts
Top