Mustang Bullitt Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
1,855 Posts
Discussion Starter #1
I may have asked this before but I need this tool.

I have the frame on the car and cannot get it off to change plates.

I have asked DEE for a loan of his (if he can find it) but I need one of my own.

I ordered a security tool kit that had 4 of these in it but all 4 were too small!
I think it is about 12mm or so as the 10mm in the kit I have is slightly too small (Width of prongs). This is the type of tool that uses two prongs that insert into two small holes in the screws and turn the screw.

I got the frame at the 03 or 04 Nats from the guy that used to run the Nats. Can't remember his name now and he PROMISED to send me the tool, but that was several years ago and still no tool.

When I got the frame at the Nats, Dee was there and I used his tool to put it on.

Now I need to get it off!

Where can I get the proper tool? And, what is it called?
 

·
Registered
Joined
·
1,855 Posts
Discussion Starter #3
YUP, That's them!

Thanks a bunch.......ordering now.
 

·
Registered
Joined
·
656 Posts
Mine was stolen with my rollaway a few years back. I e-mailed George at MGW and he sent me a new for free!
 
1 - 4 of 4 Posts
Top