Mustang Bullitt Forum banner

Foglight Wiring Question....

609 Views 6 Replies 6 Participants Last post by  RCSignals
OK,
So knowing the the Bullitt is basically a GT, except better....:smile: :smile: I would find it hard to believe that the factory would use a different wire loom on the Bullitt than on the GT.....
So the question is, has anyone done a seek and destroy mission on their Bullitt, looking for the factory foglight pigtail connectors??? Just curious....

Mike
1 - 7 of 7 Posts
GOT OATZ said:
OK,
So knowing the the Bullitt is basically a GT, except better....:smile: :smile: I would find it hard to believe that the factory would use a different wire loom on the Bullitt than on the GT.....
So the question is, has anyone done a seek and destroy mission on their Bullitt, looking for the factory foglight pigtail connectors??? Just curious....

Mike

I work for a manufacturer, so I assume the Bullitt wiring harnesses are the same also. You will have to replace the headlight switch though, since the Bullitt switch does not have the "pull out" for the fog lamps. Just my 2 cents.
BB2008 said:
I work for a manufacturer, so I assume the Bullitt wiring harnesses are the same also. You will have to replace the headlight switch though, since the Bullitt switch does not have the "pull out" for the fog lamps. Just my 2 cents.
Thanks for the input, it is appreciated. I nosed around a bit earlier, nothing too extensive....did not see any obvious connectors, but then I started wondering if it is also different with having the HID's....?? Don't know....

Thx,
Mike
For what it's worth my HVBOM sheet under Module Configuration lists module TDAME Front Fog Lights -Enabled. It lists the fog lights themselves as "less front fog lights". There is also a section on what wiring is present, but it just lists number identifyers, not labels such as "front fog lights" etc. so I have no clue what is what.
If we replace the light switch to accomodate fog lamps, what about automatic head lights? My dealer mechanic said the sensor is along the dash or rear view mirror. Any ideas on the wiring for the sensor?
And maybe an automatic dimming rear view mirror, wiring available on that perhaps?
You need the wire harness prints from whomever builds the wire harness or Ford. You can then compare the item number from the connector you seek and see if it is on the harness level you have. The prints will tell you what connectors are present on each harness level, such as AA,AB,AC and so on.
Check eBay for a wiring manual. Tehy show up quite often.

If you look in the Power Distribution box it appears the fuse positions for the fog lights are in place. You just have to trace the wiring to ensure the correct loom is also there. You'll also need the Fog light light switch as has been mentioned
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top