Mustang Bullitt Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
2,090 Posts
Discussion Starter #1
Just got the TeamBreed cast aluminum valve covers installed. A guy who is a master mechanic installed them and I did the dummy stuff like shinning a light on screw heads, holding back wires, etc. I never dreamed the job would be so difficult and like I said the guy was really good. I think one of the things that make if so difficult was the fact that the valve covers were just a little taller than the orginals. But anyway they are on and they look great. I will take pics tomorrow and post. By the way I am not totally happy with the satin oil cap cover I bought from UPR. I thougt it would fit tightly over the existing oil cap but it just sort of sits there and I was afraid to leave it on while driving. Maybe it is just supposed to be used for shows. Thoughts?
 

·
Registered
Joined
·
10,404 Posts
Take some clear silicone and put it on the cover, then put the cover on the oil cap. Make sure the oil cap is clean. Later if you desire you can remove the cover with some pulling.
 
1 - 5 of 5 Posts
Top