Mustang Bullitt Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
1,065 Posts
Discussion Starter #1
Hi all,
I've got the stock H off and the new highflow MAC H arriving in the brown truck any minute.
I've been told to replace the driver's side studs with 10-1.5X30mm bolts in order to prevent leaks. How do I remove the old studs??????????

_________________
Dennis
Black#5578 born Wed 8-22-01
SteedaTri-Ax,DensChrgr100mm,MGW satin & shift handle,FordRcng3.73's & Alum.Drvshft,rear mudgrds,30mm H&R spacers rear whls,AutoLogic chip


<font size=-1>[ This Message was edited by: Dennis on 2001-11-28 16:50 ]</font>
 

·
Premium Member
Joined
·
4,120 Posts
Unless there is something I missing,,, I would always just take two nuts and tighten one up against the other using two wrenches and then you should be able to back the stud out.
 

·
Registered
Joined
·
1,065 Posts
Discussion Starter #3
Thanks...that's a wise solution. I was actually able to get them out with my big universal wrench on the squared-off ends of the studs. Thanks for your quick response, though...much appreciated!
 

·
Banned
Joined
·
7,235 Posts
I took the OE studs out,turned down the shoulder on them and reused them....no problem.

<font size=-1>[ This Message was edited by: Mus408 on 2001-11-28 18:59 ]</font>
 
1 - 4 of 4 Posts
Top