Mustang Bullitt Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
667 Posts
Discussion Starter · #1 ·
I bought a bunch of MGW accessories for my interior and I don't really like the AC knobs. I remember them having a small allen wrench screw in them...but that is under the AC panel now. Does anyone know how to get these suckers off?
 

·
Registered
Joined
·
140 Posts
I think the A/C knobs just pushed on. Try pulling them off.
 

·
Registered
Joined
·
667 Posts
Discussion Starter · #3 ·
Everytime I am at a red light...I try. They are machined perfectly. I think I'm going to have to get the entire assembly off the ac panel.
 

·
Registered
Joined
·
41 Posts
Those are a bitch to try and take off! I am glad I like mine! I just would like MGW to make the illuminated window green to match the rest of the dash.
 

·
Registered
Joined
·
394 Posts
Shayesky,

I want to do the same thing. I just haven't figure out what to put in the hole to make it illuminate green.

I also want to figure out how to get them to match the shifter knob. It's a little thing but I think they would look more integrated if they matched the shifter knob.

I have tried pulling them off and they are on there very well!

Eric
 

·
Registered
Joined
·
41 Posts
I took a look at the factory knobs, and I was thinking if one went to a photographic store and picked up a green gel, it could be cut and placed over the little hole on the underside of the knobs. I got satin. The knob and the knobs are close enough. I make sure to drive around with my fog lights on, and tc off, so my center console is multi-colored :smile:
 
1 - 8 of 8 Posts
Top