Mustang Bullitt Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
407 Posts
Discussion Starter · #1 ·
Ok keeping my new bullitt all motor and shooting for the magic 400+rwhp. Here is what I got and what I am getting to get there. I will also have a built rear end(4.10's, the eaton diff I have sitting, and the frpp girdle cover). Thoughts?

Parts I have that area waiting to get installed(from 06 gt)
-bassani longtubes, shorty catted x-pipe, and race axle backs
-spyder drive shaft
-meziere electric water pump
-airaid intake(open to 100mm when I install the cams/heads)
-steeda race charge motion delete plates

Parts I am getting
-steeda crank only udp
-comp stage II spr cams
-jpc custom heads
-39lb injectors
 

·
Registered
Joined
·
29,355 Posts
navyman8903 said:
Ok keeping my new bullitt all motor and shooting for the magic 400+rwhp. Here is what I got and what I am getting to get there. I will also have a built rear end(4.10's, the eaton diff I have sitting, and the frpp girdle cover). Thoughts?

Parts I have that area waiting to get installed(from 06 gt)
-bassani longtubes, shorty catted x-pipe, and race axle backs
-spyder drive shaft
-meziere electric water pump
-airaid intake(open to 100mm when I install the cams/heads)
-steeda race charge motion delete plates

Parts I am getting
-steeda crank only udp
-comp stage II spr cams
-jpc custom heads
-39lb injectors
That should be a Very Nice Ride............


tigerhonaker
 

·
Registered
Joined
·
2,965 Posts
just a thought to consider, but getting 400 rwhp out of a 3v in NA form is going to really compromise the car as a daily driver. i would suggest trying to find someone that has a car with big cams and see if they will let you drive it.
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top