Mustang Bullitt Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
407 Posts
Discussion Starter · #1 ·
Ok keeping my new bullitt all motor and shooting for the magic 400+rwhp. Here is what I got and what I am getting to get there. I will also have a built rear end(4.10's, the eaton diff I have sitting, and the frpp girdle cover). Thoughts?

Parts I have that area waiting to get installed(from 06 gt)
-bassani longtubes, shorty catted x-pipe, and race axle backs
-spyder drive shaft
-meziere electric water pump
-airaid intake(open to 100mm when I install the cams/heads)
-steeda race charge motion delete plates

Parts I am getting
-steeda crank only udp
-comp stage II spr cams
-jpc custom heads
-39lb injectors
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top