Mustang Bullitt Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
2,024 Posts
Discussion Starter #1
I noticed on my Bullitt that the oil pressure gauge needle does not move when you rev up the engine, or go down while idling. When I start her up the needle moves to a little over 1/2 on the gauge and stays there with NO movement what so ever. Is anyone else experiencing this? :???:
 

·
Registered
Joined
·
116 Posts
Mine acts in about the same fashion. My understanding is that these oil pressure gauges are grossly inaccurate and that the only knowledge you can really garner from them is "yep, got some oil in the engine." Wouldn't be too concerned.
 

·
Registered
Joined
·
2,024 Posts
Discussion Starter #3
kfengler

Thank for the info.If you can remember, try and find out what ohm resister I will need and where to solder. I would like my oil pressure guage to ACT like an oil pressure guage.
 

·
Registered
Joined
·
2,024 Posts
Discussion Starter #6
kfengler

Thank you much! I will check into it and see if I can find a sending unit that will work. You guys are GREAT! :grin:
 
1 - 6 of 6 Posts
Top