Mustang Bullitt Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
543 Posts
Mus408, not sure why you are looking for bolts. Go to Autozone and ask them to loan you a crankshaft pulley puller or you can buy one from them for $15 bucks. Leave the belt on and put the car in 5th with the hand brake applied. Remember to remove the flat washer after removing the center crankshaft pulley bolt. Then attach the puller to the three bolt holes. When installing the new pulley fill the key slot with hi temp RTV. Partially (I stress partially) seat the Steeda pulley with the Steeda bolt. Finish seating it with the stock bolt. Don't forget to reuse the flat washer. Torque to 115 ft lbs.

John
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top