Mustang Bullitt Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1,574 Posts
Discussion Starter · #1 ·
Did you get your gears installed? What do you think?

Did you dyno while you were there?
 

·
Registered
Joined
·
2,060 Posts
Got the gears. They're awesome!

Shifter and MAF didn't come in Saturday, so I think I'll have them install the shifter tomorrow and wait until Saturday to install the MAF. Ran into Jim at the DYNO EDGE Saturday while I was there. He's dynoing his cobra Saturday at 9am. Chris is going to dyno my bullitt then too. 1st withought the MAF and then with. You should come down

What's a good number to get a hold of you?
 

·
Registered
Joined
·
1,574 Posts
Discussion Starter · #3 ·
cell phone...610-0434 I'll swing down there. Though 9am might be a little early, I'll get there as early as I can.

<font size=-1>[ This Message was edited by: Barnaby on 2002-01-06 23:24 ]</font>

BTW, check out Speedworx new forum www.speedworx.com/forums

<font size=-1>[ This Message was edited by: Barnaby on 2002-01-06 23:25 ]</font>
 
1 - 3 of 3 Posts
Top