I have 2 sets of uppers one with 15k miles and one set with 23k
Rear Upper Control Arms Discontinued
Apparently the OEM rear upper control arms for FOX and SN95 Mustang axles are no longer available. Anybody know if this is permanent situation or know of an alternative solution when these need to be replaced (other than torque arm)? The axle-side bushings for the rear uppers are still available.
I know that aftermarket uppers are available from various suppliers but from what I've read our stock suspensions need those rubber bushings to twist and flex or else you're going to rip the torque box out of the floor pan. So unless you have a straight line drag car sticking to the stock uppers are a must.
I know that aftermarket uppers are available from various suppliers but from what I've read our stock suspensions need those rubber bushings to twist and flex or else you're going to rip the torque box out of the floor pan. So unless you have a straight line drag car sticking to the stock uppers are a must.
1 - 1 of 10 Posts
1 - 1 of 10 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Mustang Bullitt Forum
A forum community dedicated to Mustang Bullitt owners and enthusiasts. Come join the discussion about performance, production numbers, restoration, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
Recommended Communities
