Mustang Bullitt Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
351 Posts
Discussion Starter #1
Has anyone noticed the back window roof moulding where it meets the trunk area, if on both sides it is even the space between where the moulding ends and the body?
 

·
Registered
Joined
·
199 Posts
I don't quite get the question.
 

·
Registered
Joined
·
351 Posts
Discussion Starter #3
<TABLE BORDER=0 ALIGN=CENTER WIDTH=85%><TR><TD><font size=-1>Quote:</font><HR></TD></TR><TR><TD><FONT SIZE=-1><BLOCKQUOTE>
On 2001-07-12 22:42, Bullitt1164 wrote:
I don't quite get the question.

</BLOCKQUOTE></FONT></TD></TR><TR><TD><HR></TD></TR></TABLE> What i meant to say was, the roof moulding that curves over the side windows and than down the left and right sides to meet the trunk area on my #569 the gap between the end of the moulding and where it meets the trunk area, is 1/8" drivers side and 3/8" passengers side. Almost as if a clip is missing or something.
 

·
Registered
Joined
·
57 Posts
you are refering to the C Pillers, yes mine are the same way, also, when mine arived i had to have my drivers side c piller taken of and put back on due to it not sitting down all the way.
 
1 - 5 of 5 Posts
Top