Mustang Bullitt Forum banner
1 - 1 of 12 Posts

· Registered
75 Posts
I installed one on my bullitt and the SOTP was VERY good! Definately worth getting. I set mine at 14 degrees and run 91 octane gas with no problems. Most noticable on the botton end torque. Very easy to put on as well...the only problem i had was getting the nut off the crankshaft pulley...i needed an impact wrench. but other than that it was very very easy, about 30-40 mins.

Densecharger 100mm, Steeda Tri-Ax,
Steeda T/A

<font size=-1>[ This Message was edited by: #2971 on 2002-01-03 22:14 ]</font>
1 - 1 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.