[BullittMike]

What do you guys think of this? Anyone tried it?

http://www.tornadofuelsaver.com/info/

I saw in infomercial on it at about 3 in the morning. Hard to believe it adds that much power.

 

[01GTB]

I have read about it on other boards and the concensus is that it's

I have no experience with it, but I don't think I would waste my money. Consumer reports tested it on two vehicles, one showed no improvement and one was worse. I don't much care about their opinion, but it does jive with others.

 

[McQ Stang]

I have had a good experience with the tornado. Go see my post in the MODS section.

Randy

 

[Bullitt#4660]

Nothing like putting a little extra restriction in the intake tube, the restriction that people spend hundreds trying to reduce with extrude honing, etc..........concensus says: POS!
with the exception of McQ's beer bong application of course.

_________________

Jay, Irvine CA
True Blue #4660
Vortech supercharged / Steeda Tri-Ax / Ford alum D/S / 30mm wheel spacer / Xenon rear spoiler / Powerslot rotors & Hawk HPS pads / MGW interior

<font size=-1>[ This Message was edited by: Bullitt#4660 on 2001-12-15 22:29 ]</font>

<font size=-1>[ This Message was edited by: Bullitt#4660 on 2001-12-15 22:30 ]</font>

 

[01GTB]

<TABLE BORDER=0 ALIGN=CENTER WIDTH=85%><TR><TD><font size=-1>Quote:</font><HR></TD></TR><TR><TD><FONT SIZE=-1><BLOCKQUOTE>
On 2001-12-15 22:11, McQ Stang wrote:
I have had a good experience with the tornado. Go see my post in the MODS section.

Randy
</BLOCKQUOTE></FONT></TD></TR><TR><TD><HR></TD></TR></TABLE>

My bad. Just saw it :grin:

 

[BULLITT #1042 (Ray Ackerman)]

It works great!!! I picked up 140rwhp!!!! But you must order the one for the Bullitt. They only make them for the DHG Bullitt's. :-B