Mustang Bullitt Forum banner
1 - 7 of 7 Posts

· Registered
Joined
·
120 Posts
Discussion Starter · #1 ·
Noticed a few days ago that my passenger side tail light has been retaining moisture on the inside and was wondering if anyone else has been having a similar problem???? Anyway, my beautiful baby Bullitt is going in for a check up this week!!!!
 

· Registered
Joined
·
7,944 Posts
Mine had one that leaked and they replaced it. Looks good now. They have replaced the right front headlight twice. Now they are going to replace the left front, but because they scratched it when they put the new engine in;-(...

Take care.

Bud
#227
http://www.sonic.net/budacad/bullitt/bullitt.htm
 

· Registered
Joined
·
1,065 Posts
My lights are all fine so far, but with all the discussion here about interior moisture and spots it led me to wondering...

Should I put a little bead of silicone around all the Bullitt's plastic light joints as a preventative measure? Has anyone else done this?
As usual, I look forward to your thoughts and input.
 

· Registered
Joined
·
255 Posts
Dawnygirl: A fellow bullitthead and right down the street! I have yet to see another Bullitt anywhere on the road in the past 6 months. Good to see one finally, maybe we will run into each other out there.
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top